Kitchen hood filters: a hot soapy soak for the metal one, and never wash the charcoal
Clean the grease mesh monthly by hand or in the dishwasher; replace the carbon pad roughly every six months.

There are two kinds of filter under a kitchen hood, and they need opposite treatment. The metal grease filter (mesh or baffle) gets washed and goes back in. The charcoal filter, fitted to hoods that recirculate air rather than venting it outside, never gets washed: it gets replaced. The steps below come from Whirlpool’s official product-help page.
Before you start
- Switch off the fan and the lights.
- Wait until the bulbs and surfaces are completely cool before touching the filter.
Taking the filter out
- Support the underside of the filter with one hand.
- Pull the handle or press the spring latch with the other, and the filter drops out of its slots.
- If a charcoal pad is clipped to the back of the metal filter, unclip it and set it aside.
Method one: soak it in the sink
Best for heavy buildup.
- Fill the sink with very hot tap water.
- Add one to two tablespoons of degreasing dish liquid, or a cup of baking soda for thick oil.
- Submerge the filter completely for 15 to 30 minutes.
- Scrub gently with a soft nylon brush or sponge. Skip the wire brush: it scratches the finish.
- Rinse with clean warm water until it runs clear.
Method two: the dishwasher
- Lay the filter flat or stand it upright in a rack where it won’t block the spray arms.
- Run a normal cycle with your usual dishwasher detergent.
If the mesh is bare aluminium, avoid high-heat sanitise cycles: intense heat and harsh alkaline detergent can discolour it.
The charcoal filter
Don’t wash, rinse or soak it. Moisture ruins activated carbon. Replace it after about six months, or sooner if cooking smells hang around with the fan running, using the size listed in your hood’s manual.
Putting it back
- Let the metal filter air-dry completely on a towel. Trapped moisture collects dust or drips onto the hob.
- Angle the rear tabs into the back slots, push the front edge up while holding the latch, then let the latch go.
- Tug gently downwards. If it doesn’t sag or rattle, it’s seated.
Whirlpool recommends cleaning the metal filter once a month, or whenever grease builds up.
Photo: a metal grease filter with two charcoal filters for a kitchen hood. By Amanda Slater, CC BY-SA 2.0, via Wikimedia Commons.
Source: Whirlpool product help, “Cleaning or Replacing the Filters in a Vent Hood” (producthelp.whirlpool.com), read on 20 November 2026.
Kuwait One, once a week.
The most useful stories we published this week, in your inbox.
No spam. Unsubscribe anytime.



